Xenon bulbs
DANGER
Xenon bulbs carry a high voltage. You could
get an electric shock and be seriously or even
fatally injured if you touch the electric
contacts on Xenon bulbs. Therefore, never
remove the cover from Xenon bulbs.
Do not change the Xenon bulbs yourself, but have them replaced at a qualified workshop.
If your vehicle is equipped with Xenon bulbs, you can recognize this by the following: the cone of light from the Xenon bulbs moves from the top to the bottom and back again when you start the engine. For this to be observed, the lights must be switched on before starting the engine.
Bulbs and lamps are an important aspect of vehicle safety. You must therefore make sure that these function correctly at all times.
Have the headlamp setting checked regularly.
LED lamps
You can neither replace Xenon bulbs nor LED bulbs. Have LED bulbs changed at a qualified specialist workshop.
Bulbs and lamps are an important aspect of vehicle safety. You must therefore make sure that these function correctly at all times.
Have the headlamp setting checked regularly.
Other bulbs
WARNING
Bulbs and lamps can become very hot. For
this reason, allow them to cool down before
changing them. Otherwise, you could burn
yourself when you touch them.
Keep bulbs out of the reach of children.
Otherwise, they could, for example, damage the bulbs and injure themselves.
Never use a bulb which has been dropped.
Such a bulb may explode and injure you.
Halogen bulbs are pressurized and could explode when you change them, especially if they are very hot. You should therefore wear eye protection and gloves when you are changing them.
There are bulbs other than the Xenon bulbs that you cannot replace. Replace only the bulbs listed . Have the bulbs that you cannot replace yourself changed at a qualified specialist workshop.
If you require assistance changing bulbs, consult a qualified specialist workshop.
Do not touch the glass tube of new bulbs with your bare hands. Even minor contamination can burn into the glass surface and reduce the service life of the bulbs. Always use a lintfree cloth or only touch the base of the bulb when installing.
Only use bulbs of the correct type.
If the new bulb still does not light up, consult a qualified specialist workshop.
Bulbs and lamps are an important aspect of vehicle safety. You must therefore make sure that these function correctly at all times.
Have the headlamp setting checked regularly.
Before changing bulbs
Have the following bulbs changed at a
qualified specialist workshop:
• Additional turn signals in the exterior
mirrors
• High-mounted brake lamp
• High-beam/low-beam headlamps (Xenon
bulbs)
• Daytime running lamps
• Parking lamp/standing lamp
• License plate lamp
Individual segments of the license plate lamp LEDs may fail without a display message appearing in the multifunction display. Regularly check the license plate lamp. If necessary, visit a qualified specialist workshop.
You can replace the following bulbs:
• Fog lamp/cornering light with fog lamp
function
• Turn signal lamp (front)
• Brake/tail lamp
• Turn signal lamp (rear)
• Tail lamp/standing lamp
• Backup lamp
• Rear fog lamp
• Side marker lamps
Setting the exterior lighting
Setting options
Exterior lighting can be set using:
• the light switch
• the combination switch
• the on-board computer
Light switch
Operation
If you hear a warning tone when ...
Selector lever
Overview of transmission po
If the engine speed is too high or if the
vehicle is rolling, do not shift the
transmission directly from D to R, from R
to D or directly to P.
Do not open the drive ...
Trip menu
Standard display
► Press and hold the button on
the
steering wheel until the Trip menu with
trip odometer 1 and odometer 2 is
shown.
Trip computer "From start" or "From
...