Trailer with 7-pin connector
General notes
You can make a connection to the 13-pin socket on the ball coupling using an adapter or, if necessary, an adapter cable. Both can be obtained in a qualified specialist workshop.
Installing the adapter
Make sure that there is enough slack in the cable for cornering so that the cable cannot become detached.
► Open the socket cover.
► Insert the connector with lug 1 into groove 2 on the socket and turn the connector clockwise to the stop.
► Make the cover engage.
► If you are using an adapter cable, secure the cable to the trailer with cable ties.
When the socket is connected, the ultrasonic backing up aid is deactivated.
See also:
Opening and closing the sliding
sunroof
Overhead control panel
1 To raise
2 To open
3 To close/lower
► Turn the SmartKey to position 1 or
2 in the ignition.
► Press or pull the switch in the
corresponding direction.
& ...
Defrosting the windshield
You can use this function to defrost the
windshield or to defrost the inside of the
windshield and the side windows.
You should only select the defrosting
function until the windshield is ...
Setting the exterior lighting
Setting options
Exterior lighting can be set using:
• the light switch
• the combination switch
• the on-board computer
Light switch
Operation
If you hear a warning tone when ...